The Sacramento Chapter has utilized club funds to purchase a number of Acura NSX proprietary tools for the club members to use. These are tools that Honda made for dealer mechanics to be able to work on specific parts of the car. These tools are kept by the club president and can be borrowed by making arrangements with him and providing him with your membership card to hold until you return the tool. You must be a club member in good standing to borrow these tools.
To arrange to borrow a tool drop an email to Al Terpak at aterpak @ ucdavis.edu
 |
Locknut Wrench This tool is used to disassemble and reassembly of the rear brake caliper. This tool fits into the piston and turns it so it can be removed. |
 |
Antenna Nut Wrench Do you need to remove the antenna from your car? This is the handy tool you will need. It fits perfectly into the two notches on the antenna nut and allows you to loosen or tighten the nut without risking the finish on your rear fender. |
 |
Brake Bleeder T-Wrench This special wrench fits over the bleed nut on the ABS high pressure reservoir. When the wrench is turned, the bleeder is opened and the brake fluid goes up the center of the wrench shaft into the collection tank at the top. This tool is used when changing your ABS fluid (should be done every 30,000 miles). You will need to use this tool in conjunction with the ABS sequencer to completely flush the ABS reservoir. |
 |
Coil Spring Compressor Not a custom Acura tool, but one that has been purchased by the club because it readily fits in the tight space in the NSX wheel well. |